Programming special functions
3. Audible tone (Buzzer)
This special function allows you to programme a buzzer (lasting up to a maximum of 30 seconds) for the following functions:
–Programme end = Constant buzzer
–Fault warning = Buzzer at one second intervals
–Removing a test item from the final rinse water (this function has to be programmed by a Miele service engineer)
= 3 x short beeps followed by 2 second pause, then 3 short beeps etc.
^Turn the programme selector to STOP f.
^Switch off the machine.
^Press and hold ß and 6 at the same time, and whilst doing so, switch the machine on with the
The current programme status "P..." will appear in the display and the p / 6 indicator light will come on.
^Press 0 four times. E04 (programming level 4) appears in the display.
^Turn the programme selector to q. A number from 20 to 27 will appear in the display.
20 = Buzzer switched off
21 = Buzzer at end of programme (standard setting)
22 = Fault indication
23 = Fault indication and buzzer at end of programme
24 = Reminder to remove a test item
25 = Buzzer at end of programme and for removing a test item
26 = Fault indication and buzzer for removing a test item
27 = Buzzer for all functions (Programme end, Fault indication, Removing a test item).
^Press ß or hold pressed in until the required value appears in the display.
^Press 6. SP appears.
^Press 6 again. The change has been recorded.
Value set:
Note:
The buzzer can be switched off early by
–turning the programme selector to the STOP position f,
–pressing the ß button, or
–interrupting the power supply (e.g. by opening and closing the door).
37
