Installation
Position and secure the machine
To ensure stability the machine must first be aligned and then screwed to the worktop.
^Open the door. Secure the machine to the front edge of the worktop using screws through the holes on the left and right hand sides of the front trim.
^Do not use silicone sealant to seal the gaps between the machine and any neighbouring units as this would hinder ventilation to the circulation pump.
Depending on the requirements for building under, the following kit can be ordered from the Miele Spares Dept.:
Cover plate (protects the worktop)
The underside of the worktop is protected against water damage by a stainless steel plate.
Decor frame and decor panel (optional)
If you wish to fit a decor panel to the machine this can only be done by a Miele Service technician. Contact Miele for details.
Decor panel dimensions:
Door panel H x W: 442/586 mm
Service panel H x W: 117/586 mm
46
