Programming functions
DOS 1 (liquid detergent)
Setting the detergent dosage
The dosage concentration only needs to be set for liquid detergents. Set the concentration according to the detergent manufacturer's recommendations. Do not change the setting if you are using powdered detergent in the door dispenser.
Step | Display / Result | ||
Press the "Drying" button until E02 | E02 | ||
appears in the display. |
|
| |
|
|
|
|
Turn the program selector to |
|
| |
"Inorganica". |
|
| |
Using door dispenser | 10 = 10 sec dosage length | ||
Using DOS module | 1.00 = 1.0 % dosage concentration | ||
Press or hold down the "Display" | 0.50 The dosage time / dosage | ||
button until the required value appears | concentration is now set. | ||
in the display, e.g., 0.5. |
|
| |
|
|
|
|
Dosage concentration setting: |
|
| |
|
|
|
|
Priming the dosage system |
|
| |
The dosage system does not need to be primed (cleared of air) unless:
–the dosage concentration is being set for the first time,
–the liquid detergent container was inadvertently completely emptied .
Step | Display / Result |
Press the "Drying" button until E02 | E02 |
appears in the display. |
|
Turn the program selector to "Custom". d§1
Press the "Display" button. | The dosage system will be primed |
| automatically. Priming is complete |
| when 0 appears in the display. |
Exit the programming mode. Start "Rinse" program.
This will rinse away any agents that entered the wash cabinet during priming.
35
