Programming functions
Buzzer
The buzzer can be programmed for the following functions:
–a continuous tone at the end of a program,
–an error signal that beeps in
–a
signal.
The numbers shown in the display correspond to the following settings:
20Buzzer off
21End of program (factory setting)
22Error
23End of program + Error
24
25End of program +
26Error +
27All functions (End of program + Error +
Step | Display / Result |
Press the "Drying" button until E04 appears in the | E04 |
display. |
|
|
|
Turn the program selector to "Inorganica". | 21 |
|
|
Press and hold the "Display" button until the | 26 |
required value appears in the display, e.g., 26. |
|
Value selected:
The buzzer will sound for 30 sec during the selected setting.
To switch it off earlier:
–Turn the program selector to .
–Press the "Display" button.
–Interrupt the power supply, e.g., open the door.
37