Electrical connection
,All electrical work must be carried out by a suitably qualified electrician in accordance with local and national safety regulations.
–Connection should be made via a suitable isolator, with an
–The electrical connection is made through a receptacle according to national requirements. The receptacle has to be easily accessible after installation.
–To increase the security it is recommended to install a protective switch (30 mA) before the machine.
–For technical data see the data plate or wiring diagram supplied.
The machine must only be operated with the voltage, frequency and fusing shown on the data plate.
The machine can be converted according to the supplied converting diagram and wiring diagram.
The data plate is located at the rear of the machine and behind the plinth on the plastic cover.
The wiring diagram is supplied with the machine.
See also the supplied installation diagram.
A damaged power cord must only be replaced with a genuine Miele cord by a Miele service technician.
WARNING
THIS APPLIANCE MUST BE GROUNDED
Grounding connection
^The ground lead must be connected to the screw connection point (marked with the ground symbol 8) at the back of the machine.
The machine must only be operated with the voltage, frequency and fusing shown on the data plate located on the rear of the machine, and on the plinth (behind the service panel).
The conversion diagram and the wiring diagram is secured to the inner side of the service panel.
68
