Loading the machine
Spring adapter for the water connection
The spring adapter for the water connection must be properly engaged when a basket or the injector wagon is inserted into the machine. It must be
4 - 5 mm higher than the water inlet in the machine.
If this is not the case, the adapter needs to be adjusted as follows:
^ Loosen the locking ring a. |
^Move the adapter up to the proper height b.
^Tighten the locking ring c.
Adjusting the upper basket
The upper basket can be adjusted above and below the middle position, by 2 cm.
Depending on the height selected and which inserts are used, labware of various heights can be arranged in the baskets.
To adjust the upper basket:
^Pull the upper basket out as far as it will go, lift it up off the runners and remove.
^Use a wrench to unscrew the roller bearings on either side of the basket, then reposition as required.
26
