Plumbing
DI Connection (pressurized)
The machine comes factory standard for connection to a pressure resistant system. The recommended water pressure (flow rate) is 25 - 60 psi however, water pressure that is
10 - 147 psi is acceptable.
^The DI pressure tested hose (marked "H2O pure" with a 3/4" hose thread must be connected to the
If the DI water connection is not used, the electronic needs to be reprogrammed by Miele Technical Service. The water intake hose remains at the rear side of the machine.
DI connection (unpressurized) (optional)
For connection to 1.23 - 8.7 psi the machine must be modified, if this has not done at the factory. If a feed pump is to be installed, this must only be done by Miele Technical Service.
The discharge port for any DI container (unpressurized) must be at least the height of the upper edge of the machine (see "Installation instructions").
71
