Problem solving guide
With the help of the following notes, minor faults in the performance of the appliance, some of which may result from incorrect operation, can be put right without contacting the Service Department.
Repair work to electrical appliances should only be carried out by a suitably qualified person in strict accordance with current local and national safety regulations. Repairs and other work by unqualified persons could be dangerous. The manufacturer cannot be held liable for unauthorised work.
Check and fault messages
Problem | Possible cause | Remedy |
The programme stops | This is not a fault. | – Use the Warm air |
and 0 and Finish appear | The electronic unit has | programme (timed |
in the display. | recognised that there is | drying) to dry individual |
The buzzer sounds. | no laundry in the drum | items. |
| and cancelled the | – To select a new |
| programme. | programme, switch the |
| Drying individual | dryer off and on, or |
| garments or items which | – Open the door, place |
| are already dry can also | more laundry in the |
| cause the programme to | drum, then close the |
| be cancelled. | door. |
The Low temperature | The electronic system | You will need to |
indicator light starts | lock is activated. | deactivate the system |
flashing after the dryer |
| lock before the dryer can |
has been switched on |
| be used (see "Electronic |
and |
| system lock"). |
display. |
|
|
The programme stops | No obvious cause. | – Switch the dryer off |
and Cooling down or |
| and then on again. |
Finish flashes in the |
| – Then start the |
display. |
| programme again. |
The buzzer sounds. |
| If the programme stops |
|
| again and Cooling down |
|
| or Finish flashes again, |
|
| there is a fault. Contact |
|
| the Miele Service |
|
| Department. |
28
