Programmable functions
Adjusting the dryer's electronics for very soft water
In some areas of the UK, water is extremely soft which can affect the sensitivity of the control electronics. If the dryer is installed in an area of very soft water, you should contact your local water supplier for information and advice regarding water hardness and water conductivity. If the water conductivity is less than 150 µS, the following programmable function will need to be activated.
Important. This programmable function should not be activated if, despite the water being extremely soft (as would be the case if a water softener were used), its conductivity is greater than 150 µS.
Follow steps to to programme and store in memory.
Before you begin, first ensure that:
–The tumble dryer is switched off.
–The door is closed.
Press the Start/Stop button and keep it pressed in whilst carrying out steps
Press the button in.
Wait until the indicator light for the Start/ Stop button lights up constantly . . .
. . . and then release the Start/Stop button.
Press the Low temperature button seven times.
–The Low temperature indicator light will flash on and off slowly once and will then flash on and off quickly twice.
–P and 0 (default setting) will flash alternately in the display.
The number which appears alternately in the display with P means:
0Default setting
IAdjusted for very soft water
(the Automatic plus indicator light will also flash)
Pressing the Start/Stop button switches from one number to the other.
Switch the dryer off with the button.
The setting you have selected is now stored in memory. You can change it again at any time.
52
