Installation
Rear view
Protruding lid for holding when moving the dryer (see arrows)
Air inlet vent for cooling the condenser unit
Mains connection cable
Hose for external drainage of condensed water
Accessories for connection to a sink drain outlet
Installation site
Make sure the dryer door can be opened without hindrance after installation.
Transporting the dryer to its installation site
When moving the dryer, hold it by the lid where it protrudes to the rear. To manoeuvre the dryer out of its packing case to its installation site you will also need to hold it by the front feet.
Building under a continous worktop / in a kitchen run
A
N.B. If you wish to push your appliance under a worktop and there is space to do this without removing the lid the
–The
–N.B. When
–The electrical socket must be located in an accessible position near the appliance.
With niche heights of:
–
–
* Miele accessory available to order
Replacing the lid
If the lid has been removed in order to fit a coverplate, ensure that, if the lid is ever replaced, it fits securely into the rear holders. Otherwise, it is not properly secure for transport.
37