Levelling the appliance
The dryer must be perfectly level to
ensure safe and proper operation.
^The screw feet can be adjusted to
compensate for any unevenness in
the floor.
,The air inlet and outlet vents on
the front of the dryer must not be
covered as this would prevent
sufficient ventilation for cooling the
condenser unit.
,Do not block the gap between
the bottom of the tumble dryer and
the floor with plinth facings, deep
pile carpet etc. This would hinder a
sufficient flow of air to the dryer.
Room ventilation
The air which is taken in when the dryer
is in operation is blown out of the front
of the dryer and warms up the air in the
room. It is very important to ensure
adequate ventilation, e.g. by opening a
window. Otherwise drying times may be
longer.
Washer-dryer stack
The tumble dryer can also be
combined with a Miele washing
machine in a washer-dryer stack. The
appropriate "WTV" stacking kit
(available to order) to match your dryer
is required.
,Stacking kits must only be
installed by a suitably qualified fitter.
Before moving the tumble dryer
again (e.g. when moving house)
After each use a small quantity of
condensed water will collect in the area
around the pump. This water can run
out if the dryer is tipped up when it is
being moved. It is a good idea to run
the Warm air programme for
approximately 1 minute before moving
it. Any remaining condensed water will
then be fed into the condensed water
container or out through the drain hose.
Installation
38