Miller Electric 301 G manual Operating Auxiliary Equipment, 240 V 50 a AC Receptacle RC1

SECTION 7 − OPERATING AUXILIARY EQUIPMENT

7-1. 60 Hz Generator Power Receptacles And Circuit Breakers

2 4

1

See Section 7-2for RC3 information.

		3
	Controlling Engine Speed And Weld/Generator Power Output
Engine Controls		Generator Power	Weld Output
		Output
	Engine Speed
Either
Run/Idle	1800 rpm
position.			Welding Not
	(Power Speed)
	Continuous	5 kW/kVA Total From	Recommended
		All AC Receptacles
	No Load: 2400 rpm		3600 rpm:
	(Idle Speed)
	Load: 3600 rpm		20 − 300 A
		2.4 kW/kVA at 60-120
	(Weld Speed)
		Hz From AC
		Receptacle RC3 Only

No Load: 1800 rpm	5 kW/kVA Total From
(Idle Speed)		3000 rpm:
	All AC Receptacles
Load: 3000 rpm
	At 1800 rpm.	20 − 220 A
(Weld Speed)	At 3000 rpm, Output
	Available Only At 2.4
	kW/kVA 60-120 Hz AC
	Receptacle RC3

YIf unit does not have GFCI re- ceptacles, use GFCI-protected extension cord.

.Weld output and 60 Hz generator

power output at receptacles RC1 and RC2 are not available at the same time. When welding, gen- erator power is available from AC receptacle RC3 only (see Sec- tion 7-2).

.Generator power is available at

receptacles RC1 and RC2 only at 1800 rpm. If generator is not locked at 1800 rpm, engine speed increases in response to weld load and generator power output stops at receptacles RC1 and RC2. Generator power load does not affect engine speed.

1 240 V 50 A AC Receptacle RC1

RC1 supplies 60 Hz single-phase power at 1800 rpm. Maximum output is 5 kVA/kW(20 A at 240 volts ac). For 60 Hz generator power at RC1, set controls as shown in table.

2120 V 20 A AC Duplex Receptacle RC2

RC2 supplies 60 Hz single-phase power at 1800 rpm. Maximum output from RC2 is 2.4 kVA/kW (20 A at 120 volts ac).

3 Circuit Breaker CB1

CB1 protects receptacles RC1 and RC2 from overload. If CB1 opens, the receptacles do not work. Place switch in On position to reset breaker.

4 Circuit Breaker CB3

CB3 protects RC2 from overload. If CB3 opens, the receptacle does not work. Press button to reset breaker.

.If circuit breaker continues to

open, contact Factory Authorized Service Agent.

Combined output of all receptacles limited to 5 kVA/kW continuous rating of the generator.

EXAMPLE: If 10 A is drawn from 120 V duplex receptacle RC2, only 16 A is available at 240 V receptacle RC1.

(120 V x 10 A) + (240 V x 16 A) = 5 kVA/kW

Ref. 211 909

OM-4411 Page 26