Miller Electric 301 G, DC, Trailblazer DC manual Adjusting Wire MIG Weld Puddle Consistency

5-10. Adjusting Wire (MIG) Weld Puddle Consistency

Y Stop engine and let cool.

Stabilizer DC-Z is factory connected to suit most Wire (MIG) welding applications.

To change Wire (MIG) weld puddle consis- tency, proceed as follows:

Remove cover and right side panel.

1 Stabilizer DC-Z

2 Wire /CV Weld Output Terminal

3 Stabilizer Leads 29, 28, And 27

Lead 29 − provides stiffest weld puddle

Lead 28 − provides wetter weld puddle (for mild steel)

Lead 27 − provides wettest weld puddle (for stainless steel)

Lead 29 is connected to the Wire/CV weld output terminal at the factory.

Disconnect lead 29 from the Wire/CV weld output terminal.

For wetter weld puddle (for mild steel):

Remove insulated sleeving from lead 28. Connect lead 28 to Wire/CV weld output ter- minal, reusing hardware. Insulate lead 29 with sleeving removed from lead 28. Secure sleeving with cable ties.

For wettest weld puddle (for stainless steel):

Remove insulated sleeving from lead 27. Connect lead 27 to Wire/CV weld output ter- minal, reusing hardware. Insulate lead 29 with sleeving removed from lead 27. Secure sleeving with cable ties.

Reinstall side panel.

1

2

3

Tools Needed:

3/8, 7/16 in

803 099

OM-4407 Page 22