6-2. Process/Contactor Switch On CC/CV Models
11 Process/Contactor Switch
Y Weld output terminals are ener- gized when Process/Contactor switch is in an Electrode Hot posi- tion and the engine is running.
. The unit will not return to idle speed when Process/Contactor switch is in a Wire or TIG mode and the remote contactor is on (closure between pins A and B on remote receptacle).
Use switch to select weld process and weld output on/off control (see table be- low and Section
Place switch in Remote positions to turn weld output on and off with a device con- nected to the remote receptacle.
Place switch in Electrode Hot positions for weld output to be on whenever the en- gine is running.
Use Stick positions for air carbon arc
When switch is in a Stick position, the dig circuit provides additional amperage during low voltage (short arc length con- ditions) to prevent “sticking” electrodes.
The dig circuit is disabled when switch is in Wire or TIG positions.
802 850
Process/Contactor Switch Settings
Switch Setting | Process | Output On/Off Control | |
|
|
| |
Remote − TIG | GTAW With HF Unit, Pulsing Device, Or | At Remote Receptacle | |
Remote Control | |||
|
| ||
|
|
| |
Remote − Stick | Stick (SMAW) With Remote On/Off | At Remote Receptacle | |
|
|
| |
Remote − Wire | MIG (GMAW) | At Remote Receptacle | |
|
|
| |
Electrode Hot − Wire | MIG (GMAW) | Electrode Hot | |
|
|
| |
Electrode Hot − Stick | Stick (SMAW), | Electrode Hot | |
Air Carbon Arc | |||
|
| ||
|
|
| |
Electrode Hot − Scratch | Scratch Start TIG (GTAW) | Electrode Hot | |
Start TIG | |||
|
| ||
|
|
|
