Miller Electric Bobcat 225 manual Operating Auxiliary Equipment, Standard Receptacles

. A complete Parts List is available at www.MillerWelds.com

SECTION 7 − OPERATING AUXILIARY EQUIPMENT

7-1. Standard Receptacles

					!	If unit does not have GFCI re-
						ceptacles, use GFCI-protected
						extension cord.
					. Generator power decreases as
						weld current increases.
						Set Fine Control R1 at 10 for full
						generator power.
					1	240 V 50 A AC Receptacle RC1
					RC1 supplies 60 Hz single-phase
					power at weld/power speed. Maxi-
					mum output is 10 kVA/kW.
					2	120 V 20 A AC Duplex Recep-
						tacle RC2
					3	120 V 20 A AC Duplex Recep-
						tacle RC3
					RC2 and RC3 supply 60 Hz single-
					phase power at weld/power speed.
					Maximum output from RC2 or RC3 is
					2.4 kVA/kW.
					4	Supplementary Protector CB1
					CB1 protects receptacles RC1, RC2,
					and RC3 from overload. If CB1
					opens, the receptacles do not work.
1	5	2	6	3	Place switch in On position to reset.
					5	Supplementary Protector CB2
					6	Supplementary Protector CB3
					CB2 protects RC2 and CB3 protects
					RC3 from overload. If a supplementa-
					ry protector opens, the receptacle
					does not work.
					. Press button to reset. If supple-
						mentary protector continues to
						open,	contact	Factory
						Authorized Service Agent.
					Combined output of all receptacles
					limited to 10 kVA/kW rating of the gen-
					erator.
					EXAMPLE: If 20 A is drawn from
					each 120 V duplex receptacle, only
					21 A is available at the 240V
					receptacle:
					2 x (120 V x 20 A) + (240 V x 21 A) =
					10 kVA/kW

4

803 847-C / Ref. 228 199-A

OM-4434 Page 30