Miller Electric Bobcat 225 manual Overload Protection Robin-Powered Units

. A complete Parts List is available at www.MillerWelds.com

8-7. Overload Protection (Robin-Powered Units)

! Stop engine. Disconnect negative (−) battery cable.

2	1	. Fuse F6 located in
		harness behind left
		side door.
		3

. Fuses F1, F2 located on bracket behind left side panel.

Tools Needed:

1 Fuse F1 (See Section 11-1)

F1 protects the weld excitation winding from overload. If F1 opens, weld output stops or is low.

2 Fuse F2 (See Section 11-1)

F2 protects the generator power excitation winding from overload. If F2 opens, generator power output stops or is low.

3 Fuse F6 (See Section 11-1)

F6 protects the engine wiring sys- tem from overload. If F6 opens, engine will not crank.

Replace any open fuses. Reinstall cover before operating.

NOTICE − If a fuse opens, it usually indicates a more serious problem exists. Contact a Factory Autho- rized Service Agent.

3/8 in

803 848-C

Notes

MATERIAL THICKNESS REFERENCE CHART

24 Gauge (.025 in)

22 Gauge (.031 in)

20 Gauge (.037 in)

18 Gauge (.050 in)

16 Gauge (.063 in)

14 Gauge (.078 in) 1/8 in (.125 in)

3/16 in (.188 in)

1/4 in (.25 in)

5/16 in (.313 in)

3/8 in (.375 in)

1/2 in (.5 in)

OM-4434 Page 38