SECTION 14 − STICK WELDING (SMAW) GUIDELINES
14-1. Stick Welding Procedure
5
4
2
3
6
1 7
Weld current starts when elec- trode touches workpiece.
Weld current can damage elec- tronic parts in vehicles. Discon- nect both battery cables before welding on a vehicle. Place work clamp as close to the weld as possible.
1 Workpiece
Make sure workpiece is clean be- fore welding.
2Work Clamp
3Electrode
A small diameter electrode requires less current than a large one. Fol- low electrode manufacturer’s instructions when setting weld am- perage (see Section
4Insulated Electrode Holder
5Electrode Holder Position
6Arc Length
Arc length is the distance from the electrode to the workpiece. A short arc with correct amperage will give a sharp, crackling sound.
7 Slag
Use a chipping hammer and wire brush to remove slag. Remove slag and check weld bead before mak- ing another weld pass.
Tools Needed:
stick 2007−04 −
