Miller Electric DVI-2 R manual Turn Off unit, and disconnect input power

.A complete Parts List is available at www.MillerWelds.com

4-14. Installing Optional Gas Valve, Receptacle, And Barbed Fitting For Optional Spool Gun

1

7

6

3

2

4

5

6

8

2

804 990-A

Tools Needed:

1/4 in

9/16 in

! Turn Off unit, and disconnect input power.

Remove wrapper.

1Rear Panel

2Snap-in Blank Location

3Center Baffle Barbed Fitting Hole Location

4Front Panel

5Center Baffle Ground Clip

6Circuit Board PC1

7Receptacle RC1

8Receptacle RC2

Remove snap-in blank from rear panel, and install supplied gas valve.

Connect plug from gas valve wiring harness into receptacle RC1.

Install supplied barbed fitting into center baffle hole. Connect gas hose between gas

valve and barbed fitting. Secure with hose clamps.

Remove snap-in blank from front panel, and Install supplied 4-position receptacle.

Connect plug from 4-position receptacle wiring harness into receptacle RC2.

Connect capacitors to center baffle ground clip.

Reinstall wrapper.

OM-232 386 Page 21