.A complete Parts List is available at www.MillerWelds.com
4-3. Volt-Ampere Curves
| 35 |
|
|
|
|
|
| 30 |
|
|
|
|
|
VOLTS | 25 |
|
|
|
|
|
20 |
|
|
| Range 6 |
| |
|
|
| Range 4 Range 5 |
| ||
DC |
|
|
|
| ||
|
|
|
|
| ||
15 |
|
| Range 3 |
| ||
|
|
|
| |||
|
|
| Range 2 |
|
| |
|
|
| Range 1 |
|
| |
| 10 |
|
|
|
|
|
| 5 |
|
|
|
|
|
| 0 | 50 | 100 | 150 | 200 | 250 |
| 0 | |||||
The
.Ranges 4, 5, and 6 apply to 230 VAC only.
DC AMPERES
ssb1.1 10/91 − 199 212
4-4. Connecting To Weld Output Terminals
4
1
Do not place
anything between
weld cable terminal and copper bar.
| 2 |
Tools Needed: | 3 |
| |
3/4 in (19 mm) |
|
803
Correct Installation | Incorrect Installation |
! Turn off power before connecting to weld output terminals.
! Failure to properly connect weld cables may cause excessive heat and start a fire, or damage your ma- chine.
1Weld Output Terminal
2Supplied Weld Output Terminal Nut
3Weld Cable Terminal
4Copper Bar
Remove supplied nut from weld output ter- minal. Slide weld cable terminal onto weld
output terminal and secure with nut so that weld cable terminal is tight against copper bar. Do not place anything between weld cable terminal and copper bar. Make sure that the surfaces of the weld cable terminal and copper bar are clean.
