Miller Electric PipePro Dual manual Remote-14 Receptacle Information, At the same time, as both

6-13. Remote-14 Receptacle Information

		1	Remote Switch
		2	Remote-14 Receptacle
		If the remote switch is set to MIG,
		the feeder operates normally. A re-
		mote control may be left attached
		while the remote switch is in the
		MIG mode, as the remote has no af-
		fect on the operation of the wire
		feeder.
		If the remote switch is set to Stick/
		TIG, the feeder controls and meter
		displays are disabled, allowing con-
		trol from a standard remote control.
		When a remote control is con-
		nected to the remote-14 receptacle,
		the PipePro 450 RFC will automati-
		cally adjust output control in a pri-
		mary/secondary configuration, but
		the power source must be set for
		remote operation (see the PipePro
		450 RFC Owner’s Manual for infor-
		mation).
		In this configuration, the Amp Ad-
		just control on the PipePro 450 RFC
		power source becomes the prima-
		ry, and sets the maximum amper-
		age output of the unit. The remote
		control becomes the secondary,
		and provides an amperage range
		adjustment of 0 to 100% of what is
		set on the Amp Adjust control on the
		power source.
1	2	. When in Stick/Tig mode, re-
			mote program select is still
			functional from the feeder.
		!	Do not connect a Stick elec-
			trode holder and a MIG gun
			to the same output terminal
			at the same time, as both
			will be live when the contac-

tor is on. An external polar- ity reversing isolation con- trol should be used to iso- late the outputs.

804 667-B

OM-230 009 Page 28