Miller Electric XMS 4000 manual Weld Output Terminals And Selecting Cable Sizes, 120 m

3-6. Weld Output Terminals And Selecting Cable Sizes

Y ARC WELDING can cause Electromagnetic Interference.

To reduce possible interference, keep weld cables as short as possible, close together, and down low, such as on the floor. Locate welding operation 100 meters from any sensitive electronic equipment. Be sure this welding machine is installed and grounded according to this manual. If interference still occurs, the user must take extra measures such as moving the welding machine, using shielded cables, using line filters, or shielding the work area.

				Total Cable (Copper) Length In Weld Circuit Not Exceeding
			30 m Or Less		45 m	60 m	70 m	90 m	105 m	120 m
		Welding	10 − 60%	60 − 100%
Weld Output Terminals			Duty	Duty		10 − 100% Duty Cycle
		Amperes
			Cycle	Cycle
		100	20	20	20	30	35	50	60	60
Positive	Negative	150	30	30	35	50	60	70	95	95
receptacle	receptacle
TIG/STICK	MIG	200	30	35	50	60	70	95	120	120
		250	35	50	60	70	95	120	2//70	2//70
		300	50	60	70	95	120	2//70	2//95	2//95
		350	60	70	95	120	2//70	2//95	2//95	2//120
		400	60	70	95	120	2//70	2//95	2//120	2//120
Negative receptacle		500	70	95	120	2//70	2//95	2//120	3//95	3//95
MIG/TIG/STICK
		600	95	120	2//70	2//95	2//120	3//95	3//120	3//120

// means 2 cables with the same section in parallel.

3-7. Remote 7 Receptacle Information (TIG And STICK Only)

Socket	Socket Information
1	+10 volts dc supply voltage to remote
2	GND Remote control circuit common
3	IREF 0 to 10 current control signal
4	Not used.

5UP 0V/10V digital signal

6Not used.

Remote 7
7	TYPE 0V/10V digital signal
Note: This remote receptacle cannot be used with a standard Miller remote control. A customer supplied remote control is required to use the
remote receptacle.
Some signals can be enabled when TIG or Stick welding. Contact Factory Authorized Service Agent for confirmation.
OM-224 043 Page 12