Using the remote control Continue | Mitsubishi Electronics HC2000

Using the remote control (Continue)

Operational range of the remote control

Front of projector

Rear of projector

30˚

30˚

30˚

30˚

Operate the remote control within a distance of 10 m from the projector, pointing the light beam at the remote control photo-sensor (front or rear) of the projector.

•Keep the remote control photo-sensor out of direct sunlight or fluorescent lamp light.

•Keep the remote control photo-sensor at least 2 m away from fluorescent lamps. Otherwise, the remote control may malfunction.

•If there is an inverter-operated fluorescent lamp near the remote control, the remote control operation may become unstable. On this occasion, stick the attached protection sticker on one of the photo-sensors that is closer to the fluorescent lamp.

When operating the remote control, keep the distance from the remote controller to the projector via the screen within about 6m. The operable range of the remote control, however, depends on the characteristics of the screen.

Reception angle

Vertical directions

15˚

15˚

15˚

15˚

Vertical directions (ceiling mount)

15˚

15˚

EN-10

Image 10

Mitsubishi Electronics HC2000 Using the remote control Continue, Operational range of the remote control, Reception angle

Contents

Please read it before using your projector HC2000 When using the projector in Europe EN-2 Contents Important safeguards EN-4 If you break or drop the cabinet Never remove the cabinetDo not modify this equipment Do not face the projector lens to the sun Inserting the batteries into the remote Checking accessoriesPreparating your projector Control Control area OverviewEN-7 Terminal panel Power / indicators areaPreparating your projector Continue Bottom side Using the picture quality adjusting buttons Using the remote controlOverview of the remote control EN-9 Reception angle Using the remote control ContinueOperational range of the remote control EN-10 Basic setup Setting up your projectorSetting up the screen Adjusting the projection angle Screen size and projection distance Setting up your projector ContinueWhen the aspect ratio of the screen is EN-12 EN-13 Viewing video images Connecting the projector to video equipmentConnecting to a DVD player EN-14 Plugging in the power cord Connecting to video equipment having a DVI-D terminalEN-15 EN-16 Viewing video imagesProjectiing images Preparation To stop projecting EN-17 How to change the settings Setting the aspect ratioEN-18 Viewing computer images Connecting the projector to a computerPlugging the power cord EN-19 EN-20 Auto Position button Auto button When connecting to a notebook computerExample of the setting procedure for external output EN-21 Menu Operation EN-22 How to set the menus EN-23 Menu operation Available settings in the menusEN-24 Installation Menu EN-25 To enable the stored image quality settings To store the image quality settingsTo store the settings EN-26 To adjust the color Color and Tint Adjusting projected imagesTo adjust the brightness Contrast and Brightness To sharpen or soften the projected image Sharpness To adjust the tone of white Color Temp Adjusting projected imagesEN-28 Special initial settings EN-29 To replace the lamp Replacing the lampEN-30 How to reset the lamp operating time EN-31 Cleaning dust in the intake vent CleaningTo clean the filter EN-32 EN-33 Asking for installationDimension Drawings unit mm To view images projected on the translucent No image appears on the screen Problem Solution TroubleshootingEN-34 Problem Solution Images are not displayed correctly Problem SolutionOthers Problem Solution EN-35 Replacement part Option / Not included in the box SpecificationsEN-36 Connectors Type of connectable signalsEN-37 Mitsubishi Projector Contact Information North America