Mitsubishi Electronics HC2000 user manual Auto Position button Auto button, EN-21

POWER button/

POWER indicator

LAMP TEMP POWER

	Main power
AC IN MAIN	switch
OFF button	ON	STANDBY
		AUTO OFF	LIGHT
		DVI-A
	DVI-D		COMP
		Video
	S-Video		BNC
		16:9
	Standard		ZOOM
		MEM2
	MEM1		MEM3
		ZOOM IN/UP
	FOCUS–/LEFT		FOCUS+/RIGHT
		ENTER
	MENU ZOOM OUT/DOWN
		BRIGHT	C.TEMP
	CONT
		COLOR	SHARP
	TINT

To stop projecting:

9.Press the POWER button on the projector or the OFF button on the remote control.

•A confirmation message is displayed.

•To cancel the procedure, leave the projector for a while or press the MENU button on the remote control or the MENU/ EXIT button on the projector.

10.Press the POWER button on the projector or the OFF button on the remote control again.

•The lamp goes out and the projector goes into a standby mode. In this standby mode, the POWER indicator blinks red.

11.Wait about two minutes for the POWER indicator to be lit in red steadily.

•During this period of two minutes in the standby mode, the intake fan and exhaust fan rotate to cool the lamp.

•Do not turn off the main power switch while the POWER indicator is blinking. Turning off the main power switch immediately after use may cause a breakdown.

•Though the fan makes loud sounds during cooling, such symptom is not a malfunction.

12.Turn the main power switch to off (or to the O position).

•For safety reasons, when you are not going to use the projector for a long time, unplug it from the outlet.

•Cover the lens with the lens cap to protect it from dust.

ENGLISH

AUTO POSITION button (AUTO button)

When the image supplied from the computer is displaced, carry out the following procedure.

1.Display a bright image (such as a full-screen display of the Recycle Bin window).

2.When the screen saver has been enabled, disable it.

3.Press the AUTO POSITION button on the projector or the AUTO button on the remote control. The projector automatically makes optimum positional settings for the input signal.

•If the image is not projected in the correct position even after you press the AUTO POSITION button (or AUTO button) several times, change the settings in the SIGNAL SETTING menu to put the image in the correct position. (See Page 29.)

•When you carry out this procedure with a dark image, the image may be displaced.

When connecting to a notebook computer:

When the projector is connected to a notebook computer, images may not be projected in some cases. In such cases, set the computer so that it can output signals externally. The setting procedure varies depending on the type of the computer. See the instruction manual of your computer.

Example of the setting procedure for external output

Press the [Fn] key and any of the keys [F1] to [F12] at the same time. (The key to be pressed depends on the type of the computer you use.)

EN-21