Monessen Hearth CDV7 manual Twist Lock Pipes, Rear Vent Installation Only, 69D3011

CDVSC7 & CDV7 Series Gas Fireplace Venting INSTALLATION INFORMATION

Twist Lock Pipes

When using twist lock pipe it is not necessary to use seal- ant on the joints. The only areas of the venting system that need to be sealed with high temperature silicone sealant are the sliding joints of any telescopic vent section used in the system.

To join twist lock pipes together, simply align the beads of the male end with the grooves of the female end, twisting the pipe until the flange on the female end contacts exter- nal flange on the male end. It is recommended that you secure the joints with three (3) sheet metal screws, how- ever, this is not mandatory with twist lock pipe. Figure 11

To make it easier to assembly the joints, we suggest put- ting a lubricant (Vaseline or similar) on the male end of the twist lock pipe prior to assembly.

Male End Female End

TWL100

Screw Holes

Figure 11 -

Twist-lock Pipe Joints

REAR VENT INSTALLATION ONLY:

Install the 4” (102 mm) vent pipe to the appliance inner collar and secure with three (3) stainless steel sheet metal screws. Install the 7” (178 mm) vent pipe to the appliance outer collar. Secure pipe to the rear cover plate using the tabs and three (3) sheet metal screws. If a 45° or 90° elbow is being used, attach the elbow to the appliance in the same manner then attach the venting to the elbow.

Sheet Metal

Screws

Tabs

Figure 12 -	KT1129
Rear Vent Installation

16 69D3011