Monessen Hearth CDV7 manual Electrical installation, Remote Wall mounted Switch, circuit, 69D3011

CDVSC7 & CDV7 Series Gas Fireplace		Electrical installation
Remote Wall mounted Switch
A remote wall switch and up to fifteen (15) feet of 18 Ga. wire	WARNING
NOTE: Extended lengths of wire may cause the fireplace not
may be used with this appliance. Attach the wall switch in a		Do not connect wall switch to (110 V)
junction box at the desired location on the wall. Figure 43. Do		circuit.
not extend beyond the wall switch wire length provided.
to function properly. Longer length of wire is permitted if the

wire is made out of larger gauge (diameter) wire. Always check with local code.

						OPTIONAL REMOTE
						WALL SWITCH
						ON
PILOT		TH	ON		RS
		HI				OFF
OFF	ON			OFF
		TP
		TH/TP
						OPTIONAL REMOTE
						CONTROL RECEIVER
						ON
Figure 43 -						OFF
Wiring Diagram for Wall Switch

Remote Wall Switch

Position the wall switch. Do not extend beyond the 15 feet of wire.

Optional DC Remote Systems

See section entitled Hearth Mount in the Millivolt hand held remote instructions supplied with the remote.

1.Using a flat head screw driver, bend the “remote” tabs up from the bottom of the fireplace. Figure 44

2.Follow the instructions on remote control to snap the remote cover plate to the remote receiver

3.Connect the wire terminal from the remote receiver. Figure 43

4.Use the screws that came with the remote control to mount the remote receiver cover to the bent up “remote” tabs. Figure 44

'Remote' Tabs

Remote Control

Receiver

Blower Speed	FP2284a
Control

Figure 44 -

Optional Control Location

30 69D3011