Motorola BT100 Input, Midstage, and Output Pads, Figure Frequency versus cable slope

3-6 Amplifier Setup

The information in Table 3-2 is shown as a graph in Figure 3-2:

Figure 3-2

Frequency versus cable slope

	1
	0
	-1															SCS-1
	-2															SCS-2
	-3
(dB)	-4															SCS-3
	-5															SCS-4
slope
	-6															SCS-5
Cable	-7															SCS-6
	-8
	-9															SCS-7
	-10															SCS-8
	-11															SCS-9
	-12															SCS-10
	-13
	40	45	50	72	108	150	211	250	300	350	400	450	550	750	870	1003

Frequency (MHz)

Input, Midstage, and Output Pads

Install model JXP-*B pads to attenuate the signal per system consists of attenuating excessive input levels. You should pad gain. Select and install the specified pad in the socket labeled

design drawings. Generally, this the input to system level for unity JXP IN on the amplifier cover.

The midstage pad (JXP) and output pads (JXP OUT, JXP 1, JXP 3, and JXP 4) can be used to adjust the gain level and achieve the gain specification. Refer to Section 6, “Operating Tips” for midstage/output padding information and recommendations.

BT100 Installation and Operation Manual