Motorola DTC700 Installation, Before You Begin, Installing the DCT700, Section

Section 3

Installation

This section provides instructions for installing and cabling the DCT700. To complete the installation, you must:

!Connect the cables

!Supply power to equipment

!Download configuration information and software

!Run operational check and diagnostics

This section also includes the procedure for performing a cold initialization of the DCT700.

Before You Begin

Before you begin, review the installation instructions, gather the required items, and complete the tasks listed below:

!Verify that you have 75-ohm coaxial cables with F-type connectors and RCA baseband phono-type cables.

!Determine if you are connecting the set-top to a standard TV or a composite (baseband) monitor.

!Place the set-top on a smooth, flat surface and remove any obstructions that could interfere with the free flow of air over, under, or around it. Advise the subscriber not to place anything on top of the unit.

Installing the DCT700

To install the DCT700:

1Determine if you are connecting the set-top to a conventional TV or to a monitor. To install the video connection:

!For a conventional TV, use a 75-ohm coaxial cable with F-type connectors.

!For a monitor, use an RCA phono cable to connect the VIDEO connector to the monitor. 2 Locate the cabling diagram that matches the subscriber’s configuration requirement.

3 Connect the cables as illustrated in the diagram.

4 Perform the basic operational check in this section after the set-top is installed.

DCT700 Installation Manual