7 - 4 Symbol DS3478 Product Reference Guide
RS-232 Host Parameters
Various RS-232 host types use their own parameter default settings. Selectin g th e ho st type sets the parameter
defaults listed in Table 7-2.
Table 7-2
Terminal Specific RS-232
Parameter
Standard
RS-232
(Default)
ICL
Wincor-
Nixdorf
Mode A
Wincor-
Nixdorf
Mode B
Olivetti Omron OPOS/
JPOS Fujitsu
Transmit Code ID No Yes Yes Yes Yes Yes Yes Yes
Data Transmission
Format Data as is Data/
Suffix Data/Suffix Data/Suffix Prefix/
Data/
Suffix
Data/
Suffix Data/
Suffix Data/
Suffix
Suffix CR/LF
(7013) CR
(1013) CR (1013) CR (1013) ETX
(1002) CR
(1013) CR
(1013) CR
(1013)
Baud Rate 9600 9600 9600 9600 9600 9600 9600 9600
Parity None Even Odd Odd Even None Odd None
Hardware
Handshaking None RTS/
CTS
Option 3
RTS/CTS
Option 3 RTS/CTS
Option 3 None None RTS/
CTS
Option 3
None
Software
Handshaking None None None None Ack/Na
kNone None None
Serial Response
Time-out 2 Sec. 9.9 Sec. 9.9 Sec. 9.9 Sec. 9.9 Sec. 9.9
Sec. 9.9 Sec. 2 Sec.
Stop Bit Select One One One One One One One One
ASCII Format 8-Bit 8-Bit 8-Bit 8-Bit 7-Bit 8-Bit 8-Bit 8-Bit
Beep On <BEL> Disable Disable Disable Disable Disable Disable Disable Disable
RTS Line State Low High Low Low = No
data to
send
Low High Low =
No data
to send
Low
Prefix None None None None STX
(1003) None None None
*In the Nixdorf Mode B or OPOS/JPOS, if CTS is low, scanning is disabled. When CTS is high,
scanning is enabled.
**If you scan Nixdorf Mode B or OPOS/JPOS without connecting the digital scanner to the proper
host, it may appear unable to scan. If this happens, scan a different RS-232 host type within 5 seconds
of cycling power to the digital scanner.