9 - 2 Symbol DS3478 Product Reference Guide
Connecting to an IBM 468X/469X Host
Connect the digital scanner cradle directly to the host interface.
Figure 9-1
IBM Direct Connection
1. Connect the modular connector of the IBM 46XX interface cable to the cable interface port on the digit al
scanner cradle. See Connecting the Crad le on page 1-4.
2. Connect the other end of the IBM 46XX interface cab le to the appropriate port on the host computer (typically
Port 9).
3. Ensure all connections are secure.
4. Pair the digital scanner to the cradle by scanning the bar code on the cradle.
5. Select the port address by scanning the appropriate bar code from Port Address on page 9-4.
6. To modify other parameter options, scan the appropriate bar codes in this chapter.
7. Connect an external power supply if required.
Host Port
Connector
Interface Cable
NOTE Interface cables vary depending on config uration. The connectors may be different from those illustrated
in Figure 9-1, but the steps to connect the digital scanner cradle are the same.
Disconnect the power supply before changing host cables or the digital scanner may not recognize the
new host.
NOTE The only required configuration is the port add ress. The IBM system controls most other digital scanner
parameters.