A-6
Configure and Environment Commands
A
Network Auto Boot Enable
[Y/N]
N Network Auto Boot function is disabled.
Network Auto Boot at power-
up only [Y/N]
Y Network Auto Boot is attempted at
power up reset only.
Network Auto Boot
Controller LUN
00 LUN of a disk/tape controller module
currently supported by the Bug. Default
is $0.
Network Auto Boot Device
LUN
00 LUN of a disk/tape device currently
supported by the Bug. Default is $0.
Network Auto Boot Abort
Delay
5 The time in seconds that the Network
Boot sequence will delay before starting
the boot. The purpose for the delay is to
allow you the option of stopping the boot
by use of the Break key. The time value is
from 0 through 255 seconds.
Network Autoboot
ConÞguration Parameters
Pointer (NVRAM)
00000000 The address where the network interface
conÞguration parameters are to be
saved/retained in NVRAM; these
parameters are the necessary parameters
to perform an unattended network boot.
Memory Search Starting
Address
00000000 Where the Bug begins to search for a
work page (a 64KB block of memory) to
use for vector table, stack, and variables.
This must be a multiple of the debugger
work page, modulo $10000 (64KB). In a
multi-162 environment, each
MVME162LX board could be set to start
its work page at a unique address to
allow multiple debuggers to operate
simultaneously.
Table A-1. ENV Command Parameters (Continued)
ENV Parameter and Options Default Meaning of Default