Chapter 6 Legacy CLI (Command Line Interface)
Cajun P120 User’s Guide 43
Sample Session
Contained below is a step-by-step configuration for the Cajun P120 unit. This
sample configuration is based on a Cajun P120 with factory default settings.
Verify that all parameters were accurately saved by using the show all or show
all list command. Exit your CLI session.
Subcommands
There are two optional subcommands that can be used with both the show and set
commands. These subcommands: [list], <index_value> and [r], can be
used either separately or combined.
List Subcommand [list]
When the list subcommand is used on the command line, each parameter and its
set value in a group will be displayed one by one on the screen.
With the show command the system will wait for you to press Enter to display the
next line.
Screen Display Explanation
CajunP120> login enters the Privileged security
level
Enter password: enable enter your password
CajunP120-priv# set ip list set parameters for the IP group
one by one
CajunP120-priv# set snmp ip set parameters in the SNMP
group one by one
CajunP120-priv# set vlan list set relevant parameters in the
Agent VLAN group
CajunP120-priv# set p120 list displays the parameters that can
be set on your Cajun P120
CajunP120-priv# set tftp list set TFTP parameters one by one
CajunP120-priv# write Saves the new configuration
Save the new configuration (y/n) y confirmation
If you receive an error, correct it and reissue the write command.
CajunP120-priv# exit exits the Privileged le vel