Chapter 6 Legacy CLI (Command Line Interface)
Cajun P120 User’s Guide 53
MIB-II System Group (MIB-II SYST)
This group provides the MIB-II configuration according to the IETF standard
MIB-II, System Group.
To view or change these parameters, type the command:
set|show mibII-syst list
The output is as follows:
mibII-syst>contact-system [UNKNOWN ]
mibII-syst>name-system [CajunP120 ]
mibII-syst>location-system [UNKNOWN ]
CAM Configuration Group (CAM)
This group includes parameters for the configuration of the CAM software. The
table below displays the parameters, a description of the parameters, the default
values, and the valid range of values.
The syntax for this command is: set|show cam list
Table 6.6 CAM Group Parameters
Parameter Description Default
Value(s) Valid Range
for Values
AGINGMODE Enables aging dis ena, dis
AGETIMEOUT Time interval for
CAM aging 63 1-63
AGINGMODE Determines whether or not aging is enabled on the CAM.
When enabled, the MAC addresses that h ave not been used
recently are deleted. The CAMENA parame ter must also be set
to enable for the aging function to work.
AGETIMEOUT The time interval for CAM aging. One (1) is the minimum
timeout and 63 is the maximum. Each timeout unit is about 8
seconds.