Chapter 7 Cajun Campus CLI (Command Line Interface)
Cajun P120 User’s Guide 73
Set Techpass Command
Use the set techpass command to change the password for the Technician
level of the CLI. The command prompts you to enter the old password. If the
password is valid, you are prompted to enter a new password and to verify the new
password.
Note: Although you can change this password, the commands for the Technician
level are intended for use by a qualified Lucent Technician only.
The syntax for this command is: set techpass
Example:
Console>(enable) set techpass
Enter old password: <old_password>
Enter new password: <new_password>
Retype new password: <new_password>
Console>(enable)
Set Defpass Command
Use the set defpass command to change all passwords back to their default
settings.
Note: To use the set defpass command your Terminal must be physically
connected to the Cajun P120’s Console Port.
The syntax for this command is: set defpass
Example:
Console>(enable) set defpass
Password were set to their default values!
Console>(enable)