Motorola PRM240 i user manual Charging the Modem Battery

PRM240i Wireless Modem User Manual ____________________________________________ Care & Maintenance

Charging the Modem Battery

Your modem’s lithium-ion battery is supplied discharged. For optimum performance, you should charge it fully before use. If during use, the Low battery indicator starts flashing red, the battery needs immediate recharging or it should be swapped with a re-charged unit.

The modem battery is automatically recharged simultaneously with the iPAQ when both units are inserted into the iPAQ Desktop Cradle (as supplied with the iPAQ) or when directly connected to the mains adaptor via the iPAQ serial port (depending on iPAQ model – refer to your iPAQ user manual)

Follow the steps below to charge the iPAQ and modem’s battery:

1.Connect your iPAQ to the modem. Slide the iPAQ into the desktop cradle.

2.Plug the iPAQ battery charger into a power source and the iPAQ cradle. The iPAQ battery charging indicator on the iPAQ front panel will flash when the iPAQ is charging and the battery charging indicator on the rear face of the modem battery will also flash when it is charging.

Note: Perform an overnight charge when charging the modem’s battery for the first time.

3.When the iPAQ and battery charging indicators fully illuminate both batteries are fully charged. If only one indicator fully illuminates, only that corresponding battery is fully charged.

4.Remove the iPAQ and modem from the cradle when fully charged.

When the modem battery is fully charged, the internal charger stops charging until the battery capacity falls below a certain value. The battery charger will then automatically start recharging the batteries again.

68P80802E60-O 21 Motorola