Motorola T80 EXTREME owner manual Basic Radio Operations

English

Using the Battery Support Bracket :

1.Remove the rechargeable NiMH battery pack from the radio.

2.Place the battery support bracket into the charging cradle.

3.Install the NiMH battery pack into the charging cradle. Ensure that the charging contacts are correctly aligned.

4.LED indicator will illuminate and remain illuminated as long as the radio is in the charger.

Note: Charge the battery pack for 14 hours.

Basic Radio Operations

Read this reference guide completely before attempting to operate the unit.

Turning your Radio On/Off

To turn your radio ON, turn the rotary knob clockwise.

To turn your radio OFF, turn the rotary knob counterclockwise.

Adjusting the Volume

Increase volume by turning the rotary knob clockwise.

To decrease volume, turn the rotary knob counterclockwise.

Adjusting the Sound (Key Beeps)

Your radio emits a beep each time one of the buttons is pressed (except the PTT and button).

Press and hold the button while turning the radio ON to switch the sound ON/OFF.

Navigating through the Menu

Your radios has two Menu functions: Select Menu and Common Menu.

1.To enter the Select Menu, press the SEL/ button.

2.To enter the Common Menu, press the MENU/GRP button.

3.Additional presses of the SEL/ button or MENU/GRP button will advance you through the Menu.

4.To exit the Menu function, do one of the following :

a.Press the MENU/GRP button,

b.Press the PTT button

c.Wait 10 seconds until the unit automatically returns to “Normal” mode.

Talking on Your Radio

1.Hold your radio 5–8 cm from your mouth.

2.Press and hold the PTT button while speaking. The appears on the display.

3.Release the PTT button. You can now receive incoming calls. When you do, the appears on the display. To

respond, repeat procedure from step 1.

Note: When you continue to transmit for 60 seconds, the radio emits TX Time Out tone and the icon flashes.

The radio will stop transmitting.

In order to speak to someone, both your radios must be set to the same channel and Sub-Code. Refer to “Selecting a Channel and a Sub-Code” below.

Selecting a Channel and a Sub-Code

To select a Channel:

1.SEL/ button to enter Select Menu. Advance until the Channel indicator blinks.

2. or to the required channel.

To select a Sub-code :

1.SEL/ button to enter Select Menu. Advance until the Sub-code indicator blinks.

2. or to the required Sub-code.

3.Exit the Select Menu.

4