English
Set Direct Call
The ID Number for Direct Call
The ID Name
1.MENU/GRP to enter Group Mode.
2.
to enter All/ Direct Call Setting.
3.
or 
to select an ID Number.
4.
or SEL/ 
to transmit Direct Call Command.
The selected Call Tone sounds. The display shows TX icon and CALL icon while transmitting.
5.MENU/GRP to go back to All/Direct Call setting.
Features on Your Radio
Channel Scan Mode
Enables your radio to scan for active channels. When activity is detected, your radio lands (stays) on that channel for 2 seconds (5 seconds for VOX ON without headset). To transmit on that channel, press the PTT button. When activity on the landed channel ends, your radio continues scanning other channels.
To turn the channel scan ON:
1.MENU/GRP to enter Common Menu. Advance to ”SCAN”.
2.SEL/ 
to turn ON channel scan.
3.MENU/GRP or PTT to turn OFF Scan mode.
Dual Watch Mode
Enables your to scan the current channel and another channel alternately.
To set another channel and start Dual Watch:
1.MENU/GRP to enter Common Menu. Advance to “2CH”.
2.
or 
to select the channel, then press SEL/ 
.
3.
or 
to select the 
.
4.The radio starts to Dual Watch.
Note: If you set the same channel and
current channel, Dual Watch doesn’t work.
5. MENU/GRP to turn the Dual Watch mode OFF.
Room Monitor
Enables your radio to detect voice/noises (according to the sensitivity level set) and transmit back to the listening radio without pushing the PTT button. The monitoring radio is not able to receive any transmissions in this mode.
To turn Room Monitor ON:
1.MENU/GRP to enter Common Menu. Advance to “ROOM”.
2.SEL/ 
to select.
3.
or 
to the desired room monitor sensitivity level.
Note: Use level 1 in quiet environments. Use level 5 in very noisy environments.
4.SEL/ 
to turn ON room monitor. MENU/GRP to turn OFF Room Monitor.
Note: When the voice/noise in the monitored room continues for more than 60 seconds, the monitoring radio stop monitoring for 5 seconds, and resumes.
8
