NPort 5110 Series User’s Manual | Web Console Configuration |
UDP Mode
Delimiter 1
Setting | Factory Default | Necessity |
00 to FF | None | Optional |
Delimiter 2 |
|
|
Setting | Factory Default | Necessity |
00 to FF | None | Optional |
Once the NPort 5110 receives both delimiters through its serial port, it immediately packs all data currently in its buffer and sends it out the NPort 5110’s Ethernet port.
ATTENTION
Delimiter 2 is optional. If left blank, then Delimiter 1 alone trips clearing of the buffer. If the size of the serial data received is greater than 1 KB, the NPort 5110 will automatically pack the data and send it to the Ethernet. However, to use the delimiter function, you must at least enable Delimiter 1. If Delimiter 1 is left blank and Delimiter 2 is enabled, the delimiter function will not work properly.
Force transmit
Setting | Factory Default | Necessity |
0 to 65535 ms | 0 ms | Optional |
0: Disable the force transmit timeout.
1 to 65535: Forces the NPort 5110’s TCP/IP protocol software to try to pack serial data received during the specified time into the same data frame.
This parameter defines the time interval during which NPort 5110 fetches the serial data from its internal buffer. If data is incoming through the serial port, NPort 5110 stores the data in the
