NPort 5110 Series User’s Manual | Web Console Configuration |
( 10 (bits) / 1200 (bits/s) ) * 1000 (ms/s) = 8.3 ms.
Therefore, you should set Force transmit timeout to be larger than 8.3 ms, so in this case, it must be greater than or equal to 10 ms.
If the user wants to send a series of characters in the same packet, the serial device attached to NPort 5110 should send that series of characters during a time interval less than the Force transmit timeout for NPort 5110, and the total length of data must be less than or equal to NPort 5110’s internal buffer size. The serial communication buffer size for NPort 5110 is 1 KB per port.
Destination IP address 1
Setting | Factory Default | Necessity |
IP address or Domain Name | None | Required |
(E.g., 192.168.1.1) |
|
|
Allows NPort 5110 to connect actively to the remote host whose IP address is set by this parameter.
Destination IP address 2/3/4
Setting | Factory Default | Necessity |
IP address or Domain Name | None | Required |
(E.g., 192.168.1.1) |
|
|
Allows NPort 5110 to connect actively to the remote host whose IP address is set by this parameter.
ATTENTION
Up to 4 connections can be established between NPort 5110 and hosts. The connection speed or throughput may be low if one of the four connections is slow, since the 1 slow connection will slow down the other 3 connections.
ATTENTION
The “Destination IP address” parameter can use both IP address and Domain Name. For some applications, the user may need to send the data actively to the remote destination domain name
TCP connect on
Setting | Factory Default | Necessity |
Start up, | Start up | Required |
Any character |
|
|
Start up: Attempts to establish a TCP connection as soon as the NPort 5110 is powered on.
Any Character: Attempts to establish a TCP connection as soon as the NPort 5110 starts receiving serial data.
