Moyer Diebel MH-6LM3, MH-6NM3, MH-60M3 technical manual Installation, Unpack the dishwasher

INSTALLATION

INSTALLATION

Unpack the dishwasher

CAUTION:

! Care should be taken when lifting the machine to prevent damage.

NOTE:

The installation of your machine must meet all applicable health and safety codes.

1.Immediately after unpacking the machine, inspect for any shipping damage. If damage is found, save the packing material and contact the carrier immediately.

2.Remove the dishwasher from the skid. Move the machine to its permanent location.

NOTE:

Refer to: To change from Straight-through Operation to Corner Operation on the next page if your machine will be placed for corner operation.

3.Level the machine (if required) by placing a level on the top of the machine and adjusting the feet. Level the machine front-to-back and side-to-side.

4.Remove the dishracks from the interior of the machine.

5.Refer to Fig. 1. Remove (2) screws that hold the front panel. Remove the front panel in preparation for service connections.

POWER	FILL
	CYCLE
	EXTENDED WASH
WASH	RINSE	WARNING!
		TURN OFF POWER BEFORE
		SERVICING MACHINE

Figure 1

Remove Front Panel

8