Moyer Diebel MH-60M3, MH-6NM3 MH-6L, Installation, Chemical Connections Cont, 7.MH-60,6N, 6L

INSTALLATION

Chemical Connections (Cont.)

Refer to Fig. 12

5.A 1/2" detergent probe injection point is provided at the rear and left side of the dishwasher.

6.Detergent may be added manually if your dishwasher is not equipped with dispensing equipment. Consult your chemical supplier for recommended amounts.

Refer to Fig. 13

7.MH-60, 6N, 6L

A 1/4" NPT rinse aid injection point is provided in the final rinse manifold. Use a liquid rinse aid.

The manifold is located on the top right side of the dishwasher.

8.MH-6L Only

A 1/8" NPT sanitizer injection point is provided in the final rinse manifold.

Models MH-60 and MH-6N do not require sanitizer.

9.Use a sodium hypochlorite (Chlorine) based sanitizer at a minimum concentration of 50PPM in the final rinse.

10.Use chlorine test papers to verify and monitor the 50PPM chlorine level.

WARNING:

! Never premix rinse aid with the sanitizing agent. Mixing may cause hazardous gases to form.

CAUTION:

! Some metals, including silver, aluminum and pewter, are attacked by sodium hypochlorinte (chlorine). Avoid cleaning these metals in a MH-6L.

Figure 12

Detergent Probe

Injection Points, 1/2"

MH-60, 6N

1/4" NPT Rinse aid Injection Point Model MH-60, 6N, 6L

MH-6L

1/8" NPT Sanitizer Injection Point Model MH-6L only

Figure 13

Rinse Aid and

Sanitizer Injection Points

(Top of Dishwasher)

15