Moyer Diebel MH-60M3, MH-6NM3, MH-6LM3 technical manual Installation

INSTALLATION

To Change from Straight-through Operation to Corner Operation

The dishwasher is shipped from the factory for straight-through operation. The following instructions explain how to change the dishwasher for corner operation.

Refer to Fig. 2

1.Place the dishwasher so that operator controls are readily accessible.

2.Minimum clearance from any wall is 5-1/4" (133mm).

WALL 5-1/4"[133mm] MIN.

WALL

.
MIN	FRONT
1/4"[133mm]-5	POWER ON
	SWITCH

Note:

Power switch is readily accessible.

5-1/4"[133mm]	MIN.	WALL
		5-1/4"[133mm] MIN.
POWER ON		WALL
SWITCH
	FRONT

Do not place the dishwasher closer than 5-1/4" (133mm) to any wall.

Figure 2

Placement for Corner Operation

Refer to Fig. 3a-3b and perform the steps below.

1.Remove the front rack guide (A). Discard the square spacers.

2.Move front rack guide (A) to the left side of the rack tracks. (See Fig. 3b) Use existing hardware.

3.Unbolt the track (B) and rack support rod (C).

4.Remove and save the two remaining fasteners from rear track.

5.Bolt (B) and (C) as shown in Fig. 3b.

Figure 3

Change the Track Assembly

B C

A

Figure 3a

Straight-through Configuration

A

C

B

Figure 3b

Corner Configuration

9