Multi-Tech Systems MT5600DSVD manual Zy=x Store Telephone Number, Data Compression Control

MultiModemDSVD User Guide			4 AT Commands, S-Registers, and Result Codes
Command:	&Zy=x		Store Telephone Number
Values:			y = 0–3
			x = Dialing command
Default:		None
Description:			Stores telephone dial string x in memory location y. Each tele-
			phone number dial string can contain up to 34 digits. Dial the
			stored number using the command ATDS=y.
			Note: DTR dialing uses the number stored in memory location 0.
Command:	%Cn		Data Compression Control
Values:			n = 0, 1, 2, or 3
Default:		3
Description:			Enables or disables data compression negotiation. The modem
			can only perform data compression on an error-corrected link.
	%C0	Disables data compression.
	%C1	Enables MNP 5 data compression negotiation.
	%C2	Enables V.42bis data compression negotiation.
	%C3		Enables both V.42bis and MNP 5 data compression negotiation.
			Note: This command controls both V.42bis and MNP-5 data
			compression, whereas the &E14 and &E15 commands control
			only V.42bis data compression. The command in effect is the
			one last entered.
Command:	%En		Line Quality Monitor
Values:			n = 0, 1, or 2
Default:		2
Description:			Controls whether or not the modem will automatically moni-
			tor the line quality and request a retrain (%E1) or fall back to a
			lower speed when line quality is insufficient and fall forward
			to a faster speed when line quality is sufficient (%E2).
	%E0	Disable line quality monitor and auto-retrain.
	%E1	Enable line quality monitor and auto-retrain.
	%E2	Enable line quality monitor and fallback/fall forward.
Command:	%L		Line Signal Level
Values:		None
Default:		None
Description:	%L		Returns a value that indicates the received signal level. The
			value returned is a direct indication (DAA-dependent) of the
			receive level at the MDP, not at the telephone line connector.
			For example, 009 = -9 dBm, 043 = -43 dBm, and so on.
Command:	%Q		Line Signal Quality
Values:		None
Default:		None
Description:	%Q		Reports the line signal quality (DAA-dependent) as a three-
			digit number. Returns the higher order byte of the EQM value.
			Based on the EQM value, retrain or fallback/fall forward may
			be initiated if enabled by %E1 or %E2.

33