MultiModemDID User Guide | Chapter 4 - AT Commands, |
|
|
Result Codes
In command mode your modem can send responses called result codes to your computer. Result codes are used by communications programs and can also appear on your monitor.
Terse | Verbose | Description |
0 | OK | Command executed |
1 | CONNECT | Modem connected to line |
2 | RING | Ring signal detected |
3 | NO CARRIER | Carrier signal lost or not detected |
4 | ERROR | Invalid command |
5 | CONNECT 1200 * | Connected at 1200 bps |
6 | NO DIALTONE | No dial tone detected |
7 | BUSY | Busy signal detected |
8 | NO ANSWER | No answer at remote end |
10 | CONNECT 2400 * | Connected at 2400 bps |
11 | CONNECT 4800 * | Connected at 4800 bps |
12 | CONNECT 9600 * | Connected at 9600 bps |
13CONNECT 14400 * Connected at 14400 bps
14CONNECT 19200 * Connected at 19200 bps
24 | CONNECT 7200 * | Connected at 7200 bps |
25CONNECT 12000 * Connected at 12000 bps
26CONNECT 16800 * Connected at 16800 bps
40 | CONNECT 300 * | Connected at 300 bps |
55CONNECT 21600 * Connected at 21600 bps
56CONNECT 24000 * Connected at 24000 bps
57CONNECT 26400 * Connected at 26400 bps
58CONNECT 28800 * Connected at 28800 bps
59CONNECT 31200 * Connected at 31200 bps
60CONNECT 33600 * Connected at 33600 bps
70CONNECT 32000 * Connected at 32000 bps, 56K rate
71CONNECT 34000 * Connected at 34000 bps, 56K rate
72CONNECT 36000 * Connected at 36000 bps, 56K rate
73CONNECT 38000 * Connected at 38000 bps, 56K rate
74CONNECT 40000 * Connected at 40000 bps, 56K rate
75CONNECT 42000 * Connected at 42000 bps, 56K rate
76CONNECT 44000 * Connected at 44000 bps, 56K rate
77CONNECT 46000 * Connected at 46000 bps, 56K rate
78CONNECT 48000 * Connected at 48000 bps, 56K rate
79CONNECT 50000 * Connected at 50000 bps, 56K rate
80CONNECT 52000 * Connected at 52000 bps, 56K rate
81CONNECT 54000 * Connected at 54000 bps, 56K rate
82CONNECT 56000 * Connected at 56000 bps, 56K rate
88 | DELAYED | Delay is in effect for the dialed number |
89 | BLACKLISTED | Dialed number is blacklisted |
90 | BLACKLIST FULL | Blacklist is full |
*When the extended result code configuration option is enabled, one of the following codes is appended to the result code, depending on the type of error control connection:
V42bis – V.42 error control
MNP5 – MNP 4 error control and MNP 5 data compression MNP4 – MNP 4 error control only
NoEC – No error control protocol
39
