Multi-Tech Systems MT5634ZBA-DID manual Tone Dialing, Result Code Format, Result Code Options

MultiModemDID User Guide		Chapter 4 - AT Commands, S-Registers, Result Codes
Command:	T	Tone Dialing
Values:		P, T
Default:		T
Description:		Configures the modem for DTMF (touch-tone) dialing. Dialed
		digits are tone dialed until a P command or dial modifier is
		received.
Command:	Vn	Result Code Format
Values:		n = 0 or 1
Default:		1
Description:	V0	Displays result codes as digits (terse response).
	V1	Displays result codes as words (verbose response).
Command:	Wn	Result Code Options
Values:		n = 0, 1, 2
Default:		2
Description:	W0	CONNECT result code reports serial port speed, disables
		protocol result codes.
	W1	CONNECT result code reports serial port speed, enables
		protocol result codes.
	W2	CONNECT result code reports line speed, enables protocol
		result codes.
Command:	Xn	Result Code Selection
Values:		n = 0–7
Default:		4
Description:	X0	Basic result codes (e.g., CONNECT); does not look for dial
		tone or busy signal.
	X1	Extended result codes (e.g., CONNECT 46000 V42bis); does
		not look for dial tone or busy signal.
	X2	Extended result codes with NO DIALTONE; does not look for
		busy signal.
	X3	Extended result codes with BUSY; does not look for dial tone.
	X4	Extended result codes with NO DIALTONE and BUSY.
	X5	Extended result codes with NO DIALTONE and BUSY.
	X6	Extended result codes with NO DIALTONE and BUSY.
	X7	Basic result codes with NO DIALTONE and BUSY.
Command:	Zn	Modem Reset
Values:		n = 0 or 1
Default:		None
Description:	Z0	Resets modem to profile saved by the last &W command.
	Z1	Same as Z0.
Command:	&Cn	Data Carrier Detect (DCD) Control
Values:		n = 0, 1, or 2
Default:		1
Description:	&C0	Forces the DCD circuit to be always high.
	&C1	DCD goes high when the remote modem’s carrier signal is
		detected, and goes low when the carrier signal is not detected.
	&C2	DCD drops on disconnect for time set by S18, then goes high
		again (for some PBX phone systems).

17