Multi-Tech Systems MT5634ZBA-DID manual Other Commands, Quick Connect Control

MultiModemDID User Guide	Chapter 4 - AT Commands, S-Registers, Result Codes
Command: +PQC=n	Quick Connect Control
Values:	n = 0, 1, 2, or 3
Default:	3
Description:	Controls the V.92 shortened Phase 1 and Phase 2 startup
	procedures (Quick Connect). When line conditions are stable,
	quick connect results in shortened connect times; however,
	significant fluctuation in line conditions from call to call can result in
	longer connect times, in which case it may be advisable to
	disable quick connect.
+PQC=0	Enables Short Phase 1 and Short Phase 2 (Quick Connect)
+PQC=1	Enables Short Phase 1
+PQC=2	Enables Short Phase 2
+PQC=3	Disables Short Phase 1 and Short Phase 2
+PQC=?	Displays the allowed values
+PQC?	Displays the current value

Other Commands

Command: +VCID=n Caller ID Selection

Values:	n = 0, 1, or 2
Default:	0
Description:	Enables Caller ID detection and configures the reporting and
	presentation of the Caller ID data that is detected after the first
	ring. The reported data includes the date and time of the call,
	the caller's name and number, and a message. Set S0=2.
+VCID=0	Disables Caller ID
+VCID=1	Enables Caller ID with formatted data
+VCID=2	Enables Caller ID with unformatted data
+VCID=?	Displays the allowed values
+VCID?	Displays the current value
Command: +VDR=x, y Distinctive Ring Report
Values:	x = 0, 1 Distinctive Ring report control.
	y = 0–255Minimum ring interval in 100 ms units.
Default:	0, 0
Description:	Enables reporting of ring cadence information to the DTE and
	specifies the minimum ring cadence that will be reported.
	The report format is one line per silence period and one line per
	ring period. The length of the silence period is in the form
	DROF=number in units of 100 ms<CR><LF>, and the length of
	the ring is in the form DRON=number in units of 100 ms<CR>
	<LF>. The modem may produce a Ring event code after the
	DRON message if enabled by the y parameter. The y parameter
	must be set to a value equal to or smaller than the expected
	ring cadence in order to pass the report to the DTE.
+VDR=0, n/a	Disables Distinctive Ring cadence reporting.
+VDR=1, 0	Enables Distinctive Ring cadence reporting. Other call progress
	result codes (including RING) are reported as normal.
+VDR=1, >0	Enables Distinctive Ring cadence reporting. The RING result
	code is reported after the falling edge of the ring pulse (i.e., after
	the DRON report).
+VDR=?	Displays the allowed values.
+VDR?	Displays the current value.

30