Chapter 2 - Installation
Chapter 2 - Installation
This chapter shows you
Safety Warnings
Use this product only with UL- and
To reduce the risk of fire, use only 26 AWG (.41mm) or larger telephone wiring.
Never install telephone wiring during a lightning storm.
Never install a telephone jack in a wet location unless the jack is specifically designed for wet locations.
Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.
Use caution when installing or modifying telephone lines.
Avoid using a telephone during an electrical storm; there is a risk of electrical shock from lightning.
Do not use a telephone in the vicinity of a gas leak.
Step 1: Mount the Feet
The modem comes with a set of
Step 2: Change the Internal Jumpers
This step is required only if:
You intend to use the modem on a leased line.
You intend to add a monophonic external speaker to your modem with the voice option. No changes are needed for stereo.
This will require you to open the modem and move one or more jumpers on the modem’s printed circuit board.
Warning: The following procedure must be performed by authorized service personnel.
Caution: The circuit board can be harmed by static electricity. Before you open the case, touch a grounded object, such as the metal chassis of your computer, to discharge any static electricity in your body, then touch the metal shell of the modem’s
Opening the Modem
1.If the modem is connected, turn it off and remove all connecting cables (including the power and line cables).
2.Turn the modem upside down.
3.On the bottom of the modem are two screws, which hold the case together. Remove both screws and set them aside.
4.Turn the modem right side up.
5.Remove the top part of the modem case.
6.To close the modem, reverse Steps
8 |
