Chapter 2 - Installation
Step 5: Configure the Modem for Your Country
Different countries have different requirements for how modems must function. Therefore, before you use your modem, you must configure it to match the defaults of the country in which you are using it. You must also do this if you move the modem to another country after it has been configured for the first country. You can use one of two configuration methods:
1.Use the Global Wizard to Configure Your Modem
2.Use AT Commands to Configure Your Modem
Using the Global Wizard to Configure Your Modem
The Global Wizard configuration utility is recommended for computers running Windows 95 or newer.
1.Insert the MultiModemZBA system CD into the
2.Click Initial Setup and Country Selection.
3.Choose either:
Run Global Wizard from CD. This will not load the wizard onto your hard drive, or
Install Global Wizard on the HD. This will install the wizard onto your hard drive for future use.
4.The Global Wizard dialog box appeared. Click Next.
5.The Global Wizard searches for your modem and identifies it. Click Next.
6.Select the country in which the modem will be used. Click Next.
7.Review your choice of country. If it is correct, click Next to configure the modem.
8.When Global Wizard announces that the parameters have been set, click Finish to exit.
Using AT Commands to Configure Your Modem
1.Run Phone Tools.
2.To configure the modem for a specific country:
Type AT%T19,0,nn, where nn is the country code in hexadecimal notation. Click ENTER. The message OK displays.
3.Then save the code by typing the following command: AT&F&W. Click ENTER. The message OK displays.
4.To verify that the correct country has been configured, type: ATI9 and click ENTER.
The country code displays:
Country | AT Command (hexadecimal) | Result code (decimal) |
Euro/NAM | AT%T19,0,34 (default) | 52 |
A list of country codes can be found on the
http://www.multitech.com/GlobalModem/config.
13 |
