BASIC ENGINE INFORMATION
18
13
12 8
6
9 |
|
|
| 11 |
|
|
|
| |
16 |
|
| 17 |
|
|
|
| 2 | |
|
|
|
| |
10 |
|
|
|
|
|
|
|
| 15 |
| 7 |
|
|
|
|
| 14 |
| 3 |
|
|
|
| |
| 5 |
|
| 1 |
|
|
| 4 | |
|
|
|
|
| Figure 6. Basic Engine Components |
BASIC ENGINE COMPONENTS | 9. |
| to adjust the |
The following refers to basic engine components and their functions that an operator may need to reference. The manufacturer’s engine manual provides further instructions and details of operation and servicing. The engine shown in Figure 6 is a Deutz BF3L2011 engine.
1. Fuel Filter — Removes dirt and water from the engine fuel.
2. Governor Lever — This lever restricts engine speed (high idle and low idle) through a speed control device
| linked to the accelerator system. |
3. | Oil Dip Stick — Remove to check amount and condition |
| of oil in crankcase. |
4. | Oil Filter — |
5.Oil Drain Plug and Hose — Remove plug and attach drain hose to drain crankcase oil.
6.Oil Filler Port — Remove to add fresh crankcase oil.
7.
8.Cooling Fan — Driven by
10.
11.Oil Fill Cap — Remove to add engine oil.
12.Lifting Eye — The lifting eye is provided if the removal/ installation of the engine becomes necessary.
13.Alternator — Located inside the fan assembly.Provides current to the electrical system and charges the battery. Driven by means of a
14.Starter — Starts engine when ignition key is rotated to the “START” position.
15.Flywheel — Main power is taken off from the flywheel end.
16. Air Intake Port — Provides air from the air cleaner to the turbocharger unit.
17. Turbocharger — Provides pressurized intake air to the cylinder by means of a turbine energized by exhaust gas that rotates the blower.
18. Air Cleaner Assembly — Provides clean filtered air to the air intake port.
PAGE22 — SP7060 PAVEMENT SAW • OPERATION MANUAL — REV. #0 (02/13/09)