Multiquip SP706030, SP706020 Loading and Transporting, LOADING, Unloading Andtransportingthe SAW

LOADING AND TRANSPORTING

LOADING, UNLOADING ANDTRANSPORTINGTHE SAW

Loading and Unloading

WARNING

When LOADING, UNLOADING or when on a STEEP SLOPE, the engine MUST BE at 1800 RPM or above to prevent loss of control.

Tie-Down Points

The saw is provided with holes at each corner of the lower frame for easy tie-down during transportation. See Figure 35.

CAUTION

NEVER tie the back end of the saw down by strapping across the handlebars. Damage to the SLH (Stay Level Handles) system will occur.

CAUTION

The use of tie-downs to secure the saw during transportation is highly recommended.ALWAYS secure the saw during transportation to prevent unwanted movement or shifting that could result in equipment damage or injury to personnel.

Figure 35. Tie-Down Points

Lifting Point

The convenient single point for lifting the saw with a hoist is located above the engine (Figure 36).

Figure 36. Lifting Point

WARNING

AVOID INJURY!

Stay clear of the saw while it is being hoisted.

To avoid possible damage to the saw, use approved rigging (minimum 3000 lb. test) when hoisting the saw.

Night Light

The night light (Figure 37) can be used on either side of the saw and can be extended and rotated for best illumination of the cutting area. Aim the light then lock it in position by tightening the lock knobs. The light can be removed for storage by loosening the lock knobs, disconnecting the light cord and sliding the light bar out of the saw.

To turn lights ON, push the rocker-style switch located on the instrument panel forward.To turn lights OFF, push rocker switch backward.

Figure 37. Night Light

PAGE38 — SP7060 PAVEMENT SAW • OPERATION MANUAL — REV. #0 (02/13/09)