FUELING THE SAW
FUELING THE SAW
This saw features an
CAUTION — Fuel Safety
Handle fuel safely.
Motor fuels are highly flammable and can be dangerous if mishandled.
DO NOT smoke while refueling.
DO NOT attempt to refuel the saw if the engine is hot or running.
Avoid spilling fuel on the control panel or engine.Clean up fuel spills to avoid falls from slipping.
DO NOT overtighten the fuel tank cap.
WARNING — Diesel Fuel only
Use DIESEL FUEL ONLY.
NEVER use gasoline or fuels not specifically for use in the Deutz Diesel engine.
1.Determine if the engine fuel is low. ( Figure 23)
2. If fuel level is low, remove the fuel filler cap and fill with diesel fuel (Cetane fuel number 45 or greater).
Priming the Fuel System
Saws UPTO S/N ZC3700225 utilize a fuel primer bulb when fueling the saw for the first time or refilling after running out of fuel. Locate the fuel primer bulb inside the console beneath the fuel tank (Figure 24, Item A) and squeeze the fuel priming bulb until it fills with fuel, (it will become firm when properly primed), priming the fuel transfer pump.
Saws AFTER S/N ZC3700225 utilize a fuel primer button built into the engine transfer pump (Figure 24, Item B).
WARNING — Fuel
DO NOT crank the engine without fuel in the line between the tank and the primary fuel pump to prevent damage to the primary fuel transfer pump.
A
B
Figure 24. Fuel Primer Bulb (A) or Button (B)
Figure 23. Fuel Gauge
Storage With Fuel In System
CAUTION — Fuel
DO NOT store with fuel in the tank for an extended period of time. Completely drain fuel system (tank, lines, etc.) if the unit is to be put into long term storage. For shorter or intermediate periods of time, the tank should be filled to avoid condensation that could cause contamination of the fuel.
PAGE32 — SP7060 PAVEMENT SAW • OPERATION MANUAL — REV. #0 (02/13/09)